HOME : Back -> Surveillance | Security -> Hardware -> AXIS

AXIS T8129 Power over Ethernet extender repeates the data signal and forward the PoE to the camera

Product May Vary From Image
Our Price:
$355.10
Quantity: 
Part No:
536595
Brand:
AXIS
Manuf No:
S45299
Ship Weight:
4.75 KG  Details
Usually Ships:
1-3 Days   More info
Product Description

Ethernet has a limited cable length between the switch and the camera of 100m (328 ft.). When needed to cover a longer distance, a switch is normally used as a repeater, or optical fiber may be used.To overcome this distance limit, network installers can simply connect an AXIS T8129 PoE Extender in-line with the Cat-5e or Cat-6 cable, and forward the rest to the camera. Dependent on midspan and camera type, the connection in total can be between 200-400 meters (656-1312 ft.).

Compatibility

AXIS T8129 PoE Extender is compatible with all Axis network video products with PoE, and supports both IEEE 802.3af and IEEE 802.3at. Check in the Typical set-up section for connection examples with Axis network video products.

Range

Range depends on the power required, so a 25 watt PTZ dome camera may be located 200 m (656 ft.) away using a single AXIS T8129. Or, the cable length to a regular 5 watt network camera may extend up to 400 m (1312 ft.), by fitting three AXIS T8129 at 100 m (328 ft.) intervals. Check in the Range tab for information about Maximum distances.

The table below shows the maximum distances from the network switch depending on power source, by adding an Axis PoE Extender for every 100m (328ft). The actual figures will depend on operating conditions. The range is over 24AWG (or heavier) CAT5e or CAT6 cable except where specified:

Powered device

PoE source

PoE switch or Axis 15 W
midspan (802.3af)		PoE+ switch (802.3at)Axis 30W midspan (802.3at)**Axis 60W midspan (High PoE)

Low power PoE devices

Devices that are PoE Class 1, or require under 6 watts

300m (984 ft.)400m (1312 ft.)
400m (1312 ft.)400m (1312 ft.)

Medium power PoE devices

Devices that are PoE Class 1 or 2, or require under 12 watts

200m (656 ft.)
200m (656 ft.)
300m (984 ft.)300m (984 ft.)

Full power PoE or PoE+ devices

Devices that are PoE 802.3af or 802.at compliant, or require over 12 watts

Not supported

Not supported

200m (656 ft.)*200 m (656 ft.)*

Custom High PoE devices

Devices specified for use with Axis 60W Injectors

Not supportedNot supportedNot supported200m (656 ft.)*

Note: The actual figures depend on operating conditions. Range is over 24 AWG or heavier CAT5e or CAT6 cable except where specified.

* use 23 AWG or heavier cable (typically CAT6)
** Axis 30W midspans are fully 802.3at compliant but operate at a higher voltage than most PoE+ switches, therefore it enables longer ranges then most normal PoE+ Switches.

No additional power supply

AXIS T8129 does not require any additional power supply and the connected network camera is fed by a single PoE switch or midspan. It offers two female Ethernet ports, which are both configured automatically for link speed, duplex and crossover and the full-rate network throughput is maintained.


Product Warranty


12 Month Return To Base
 


L7: 17 | TM: 41 | LM: 30 | TY: 382 | T: 422